Front Bumper
Jimny
The URNIETA SALADO Front Bumper is engineered for the Jimny JB74 / JC74, combining an integrated winch housing, an interchangeable bar system, and a recessed skid panel with design-led fitment and high-end build quality.
Why this part
exists.
The URNIETA SALADO Front Bumper is engineered for the Jimny JB74 / JC74, combining an integrated winch housing, an interchangeable bar system, and a recessed skid panel with design-led fitment and high-end build quality.
The OEM front bumper is intentionally plastic: light, regulation-friendly, and adequate for a stock Jimny. The design problem begins when the front end is asked to carry recovery loads, brush protection, and a winch. The original part was designed to deform, not as structure. The Salado response turns the bumper into a load-bearing front module while staying inside the Jimny's OEM mounting logic. The winch is recessed into the bumper geometry around a custom 8,000-lb unit, with control box, motor, and cabling hidden inside. The interchangeable U-Bar and Bull Bar keep the same structural base while allowing different build expressions.
The drawing.
Three things that matter.
Integrated Winch Housing
A fully recessed cavity holds a custom 8,000-lb winch designed and developed for this exact bumper. Control box, remote port, and motor sit inside the bumper structure. No exposed cables. No protruding hardware.
Interchangeable Bar System
Ships with two configurations: a compact U-Bar for urban builds and a full Bull Bar for serious overland use. Hot-swap between them with no chassis modification. Same bumper, different stance.
Recessed Skid Panel
The lower skid panel ships standard. It reinforces front-end protection during rock crawling and seals the winch cavity when running without a winch installed. Removable for service access.