Rock Lights LED Push Switch Factory-style LED dash control
A direct-fit push switch for your Toyota LandCruiser or Hilux factory switch panel, giving your rock lights a clean, OEM-look control point right on the dash. White LED illuminated and pre-wired, ready to slot in.
or 4 interest-free payments of $3.74 with Shop Pay & Afterpay
Item code: SW70-VW-RCK
Australian Owned and Operated.Australian Owned Certified · AO 08314
One switch, done properly.
Running rock lights from a toggle switch zip-tied to a vent or tucked under the dash is a compromise most serious 4x4 owners put up with longer than they should. This switch changes that, dropping straight into your existing Toyota factory switch panel blank so the result looks like it came from the factory floor.
Designed specifically around the switch panels found in the 70 Series, 200 Series and Hilux N80, there is no cutting, no adapting and no afterthought mounting. The white LED illumination keeps it consistent with the rest of your factory switchgear after dark, and the pre-wired harness means you spend your time under the dash connecting, not fabricating.
Built for the factory panel.
DIRECT-FIT DESIGN
Engineered to suit the factory blank switch positions in the 70 Series, 200 Series and Hilux N80 panels. No cutting or modification to your interior required.
WHITE LED ILLUMINATION
Backlit with white LED so the switch is easy to locate at night and sits visually consistent with your Toyota's existing factory switchgear.
PRE-WIRED HARNESS
Arrives pre-wired and ready to connect, cutting down install time and removing the guesswork from the wiring side of the job.
Vehicle fitment.
Installation overview.
SELECT YOUR VARIANT
Confirm your panel type before you start. Check whether your 70 Series dash has vertical, horizontal or facelift square switch blanks, or confirm your 200 Series or Hilux N80 fitment.
REMOVE THE BLANK
Use a trim removal tool to carefully pop the factory blank switch out of your dash panel. No cutting or drilling is required.
CONNECT THE HARNESS
Route and connect the pre-wired harness to your rock lights circuit according to your wiring setup.
SEAT THE SWITCH
Press the switch firmly into the panel aperture until it clicks flush. Confirm LED illumination and rock lights operation before reassembling any trim.