Kostenloser Versand für alle australischen Bestellungen über 150 $

Steering Wheel Transmitter Backlight Not Lighting on a 70 Series

The transmitter behind your wheel is powered by the horn circuit. Dark buttons with the parkers on mean no power is reaching the wheel through the horn feed. Check the horn feed first, and if the controls work until the parkers come on and then stop, check the horn booster.

Use this article if…

  • Your wheel buttons don't light with the parkers on.
  • You've measured voltage at the clock spring and the transmitter still looks dead.
  • You've fitted a boss kit or wireless module and the controls don't respond.

Know what powers the backlights

The wheel end of a PVS wireless kit runs off the horn circuit, not off the headunit.

A flashing receiver LED tells you nothing about the wheel end, because the receiver runs off the headunit's own supply. Voltage at the clock spring doesn't prove the power lead is on the horn feed.

If the buttons stay dark

  1. Turn the ignition on and look at the receiver behind the headunit. It should be lit solid red.
  2. Turn the parkers on and look at the wheel buttons. They should be backlit.
  3. If the buttons are dark, treat it as no power at the wheel and check the horn feed.
  4. Check that your horn works. No working horn means dead buttons, whatever the headunit shows.
  5. Check that the transmitter's power lead is on the horn feed.

If both lights are alive and the buttons still don't respond, the fault is in the module set itself and not in the power. If the receiver stays dark or flashes while the wheel buttons light up, work through the controls not working guide.

If your 70 Series is pre-DPF

Follow these steps only if your 70 Series is pre-DPF, has no cruise control, and has a 10-pin clock spring plug with one wire in it, the horn wire.

  1. Ignore the pink, white and blue 4-pin plug on the new wheel. Don't plug it in.
  2. Plug the original 10-pin plug back into the clock spring.
  3. Run its horn feed to the wireless module and to the back of the horn pad, in parallel.
  4. Carry on with the rest of the install as normal.

The factory brown plug at the column isn't reused on a 70 Series wheel swap.

If the controls die when the lights go on

Some vehicles don't get enough voltage to the wheel module when the parker lights are on.

  1. Find the white cable off the wireless receiver behind the headunit. That's the horn booster.
  2. Take off the steering column covers.
  3. Plug the booster into the bottom of the clock spring on the column side.

Never plug the booster into the 12-pin controls plug on the wheel. 12V straight onto the controls board can destroy it. If the controls work with the parkers off and stop when you switch them on, fit the booster before you replace anything. A starved module isn't a blown module.

Leave the clock spring alone

No PVS steering wheel kit needs the clock spring removed, replaced, re-centred or rotated. Never turn, rotate, force or dismantle it while the wheel is off the column.