Urnieta Mudflap 70 Series
Silicone-rubber flaps, metal brackets, adjustable straps
Your 70 Series wheel arch takes a beating on the track. The URNIETA kit pairs a hybrid silicone-rubber flap with reinforced metal brackets and adjustable tension straps, built for the LC71, LC76 and LC78.
Item code: URN-MDF-LC76-FF
In high demand. We're working through a backlog of orders on this range, so this item may dispatch one to two weeks later than usual.
12-Month Australian Warranty.Backed by PVS Automotive, Sydney based support. Tax Deductible for Business. GST claimable if you are registered.Often fully deductible as a business expense. Check with your accountant.
Australian Owned and Operated.Australian Owned Certified · AO 08314
Mud protection that earns its place.
The 70 Series wheel arch throws up everything the track can offer. A mudflap that shakes loose or cracks after one cold morning is worse than useless. The URNIETA set uses a hybrid silicone-rubber blend that stays flexible in extreme cold, on embedded metal brackets that reduce vibration.
It's built for the LC71, LC76 and LC78, works with the OEM and URNIETA side bars and lines up with the factory fender flares. Adjustable tension straps let you set the flap angle for the terrain.
It ships free worldwide.
Built for the 70 Series.
SILICONE-RUBBER FLAP
A hybrid silicone-rubber blend stays flexible in extreme cold. The extended width and length give fuller coverage across lift heights and tyre upgrades.
REINFORCED METAL BRACKETS
Embedded metal brackets reduce vibration and wear, and adjustable tension straps let you set the angle.
SIDE BAR COMPATIBLE
Works with the OEM and URNIETA side bars, and lines up with the factory fender flares.
Vehicle fitment.
Installation overview.
SELECT YOUR VARIANT
Confirm your model and whether it has factory fender flares before you order.
REMOVE THE FACTORY FLAPS
Remove the original mudflaps and brackets, plus the front wheel arch screws.
FIT THE FRONT FLAPS
Fix the new front brackets with the factory screws, fit the front flaps, then the tensioner bracket and strap. With URNIETA side bars, the side bar pipe is drilled and M6-tapped.
FIT THE REAR FLAPS
Transfer the rear brackets with the factory screws, bond on the rear wheel-arch blocks and fit the rear flaps. Drill the 8 mm holes for the rear tension ropes, then torque everything to spec.
Spec it
your way.
Not sure which setup suits your build? Get fitment advice, install guides, or talk to the PVS team before you buy. We are Sydney based and here to help.
