Carbon Fibre Hood
250 Series LandCruiser Prado
The 250 Series Prado bonnet line is unique to this generation, so this hood is shaped specifically for it, not adapted from an older mould. It's hand-laid dry carbon fibre, weighs just 8.5 kg and bolts straight onto your factory hinges and latch.
Item code: URNIETA043
In high demand. We're working through a backlog of orders on this range, so this item may dispatch one to two weeks later than usual.
12-Month Australian Warranty.Backed by PVS Automotive, Sydney based support. Tax Deductible for Business. GST claimable if you are registered.Often fully deductible as a business expense. Check with your accountant.
Australian Owned and Operated.Australian Owned Certified · AO 08314
Built for the new Prado.
The 250 Series Prado bonnet line is unique to this generation. It shares no profile with earlier Prado generations or other LandCruiser platforms, so your Urnieta hood is developed and shaped specifically for the 250 Series, not adapted from an older mould.
Each hood is hand-laid in the Urnieta workshop and produced in small batches. The carbon weave sits visible beneath the clear coat in your choice of gloss or matte.
Fitting is a straightforward swap. The panel uses the factory hinge mounting points and latch, nothing cut, drilled or bracketed. Free worldwide shipping is included.
What sets this hood apart.
HAND-LAID CONSTRUCTION
Each panel is laid up by hand in the Urnieta workshop. Small-batch production means close quality control over fibre alignment and resin distribution across the full bonnet surface.
250 SERIES SPECIFIC
Developed to the exact bonnet geometry of the 250 Series Prado. The profile, shut lines and mounting points aren't shared with earlier Prado or LandCruiser generations.
BOLT-ON FIT
Uses the factory hinge mounting points and OEM latch. No modifications to your vehicle needed, just a standard tool kit and one helper for the swap.
Vehicle fitment.
Installation overview.
OPEN AND SUPPORT
Open the factory hood and support it fully. Disconnect any washer nozzle lines or wiring routed through the hood before you continue.
REMOVE FACTORY HOOD
With a helper, unbolt the hood from both factory hinges. Mark the hinge position before removal to make alignment easier on refit.
FIT CARBON HOOD
Offer the Urnieta hood onto the factory hinges using your marked positions. Hand-tighten the bolts, check panel gaps on both sides, then torque to factory spec.
RECONNECT AND CHECK
Reconnect any washer lines or wiring. Close the hood slowly and check the OEM latch engages cleanly. Adjust hinge position if needed before final tightening.
Spec it
your way.
Not sure which setup suits your build? Get fitment advice, install guides, or talk to the PVS team before you buy. We are Sydney based and here to help.
