Black Border Ramp Male Colour-matched snap-lock edging for modular flooring tiles
A raw tile edge is a trip hazard in a garage or workshop. The Black Border Ramp Male ramps the edge down smoothly and snaps straight onto your tiles, no adhesive or fasteners needed.
or 4 interest-free payments of $1 with Shop Pay & Afterpay
Item code: BLACK-BORDER-RAMP-MALE
Australian Owned and Operated.Australian Owned Certified · AO 08314A proper edge to your floor.
A modular tile floor looks unfinished without a border, and a raw tile edge is a genuine trip hazard in a garage, workshop or fitout. The Black Border Ramp Male fixes both at once, ramping the tile surface smoothly down to the ground.
The snap-lock connection is purely mechanical, so you don't wait on glue to cure or hunt down fasteners. The same UV-stabilised black pigment runs through each ramp as the tiles, so the edge stays consistent instead of fading out of step.
Polypropylene handles the full range of workshop conditions, from cold winter mornings to hot summer concrete. It shrugs off oil, water and cleaning chemicals without fading or turning brittle.
Built for the border not an afterthought.
SNAP-LOCK FIT
A mechanical snap-lock connection secures the ramp to your tile edge firmly. No glue, no fasteners, no curing time.
COLOUR-MATCHED
Shares the same UV-stabilised black pigment as your tiles so the border blends in rather than standing out.
TEMPERATURE TOUGH
Rated from −40°C to +120°C, so it handles freezing winters and scorching summer floors without warping or cracking.
Installation overview.
LAY YOUR TILES
Complete your modular tile layout and check the edges where the ramp will go.
ALIGN THE RAMP
Position the male ramp piece along the exposed tile edge, lining up the snap-lock tabs with the tile connector points.
PRESS TO LOCK
Apply firm, even pressure along the ramp until each tab clicks into place. The connection is mechanical and holds without any extra fixings.
