Battery Isolator LED Push Switch Factory-style OEM dash fitment
Your LandCruiser or Hilux switch panel is built around a specific format, so a bolt-in aftermarket switch usually looks out of place. This one is sized for the factory panel, pre-wired with a white LED, and fits straight in.
or 4 interest-free payments of $4.75 with Shop Pay & Afterpay
Item code: SW70-SQ-BIS
Australian Owned and Operated.Australian Owned Certified · AO 08314Built for the factory panel.
Toyota's factory switch panels are built around a specific switch format. An aftermarket switch that doesn't match that format always looks out of place. This push switch is sized and finished to slot straight into the LC70 Facelift square switch panel, so your battery isolator looks like it was always meant to be there.
The white LED gives you a clear read on switch state without lighting up the cabin. The pre-wired harness cuts down install time so you can get back on the road, or off it.
Designed to fit right in.
OEM-LOOK FINISH
Matched to Toyota's factory switch panel finish, so the isolator sits alongside your existing dash switches without standing out.
WHITE LED ILLUMINATION
The white LED gives you an instant read on switch state day or night, without drawing attention.
PRE-WIRED
Comes pre-wired to make the install quicker. Less time splicing, more time using the vehicle the way it was built for.
Vehicle fitment.
Installation overview.
DISCONNECT BATTERY
Disconnect your vehicle's main battery before you start any electrical work, so you avoid an accidental short.
REMOVE FACTORY BLANK
Pop out the factory blank or existing switch from the square panel position in your LC70 Facelift dash.
CONNECT AND SEAT
Connect the pre-wired harness to your battery isolator circuit, then press the switch firmly into the panel until it clicks into place. Reconnect the battery and test the LED and isolator function.