Airbag Rocker Switch, Latching Up and down airbag suspension control for your dash
A dedicated rocker switch built for airbag suspension control, with laser-etched icons and dual white LED illumination. It's sized to the standard DIN footprint, so it drops straight into your existing switch panel.
or 4 interest-free payments of $6.25 with Shop Pay & Afterpay
Item code: SW70-AB-LATCH
ملكية وإدارة أسترالية.معتمدة كشركة أسترالية الملكية · AO 08314One switch, total control.
Airbag suspension is only as convenient as the controls you can reach. This latching rocker switch gives you a dedicated up and down input with instant tactile feedback, so you know where your bags are headed without looking twice.
The laser-etched icons are cut directly into the switch face, so the finish won't fade or peel over time. The dual LED setup is practical too: the upper LED lights when you press up, and the lower LED ties into your dash illumination circuit for consistent backlighting at night.
It's sized to the same standard DIN footprint used by ARB switch panels and most modern vehicle consoles, so it installs without cutting or modification. A wiring diagram is included so you can get it connected and move on.
Built for the job at hand.
LASER-ETCHED ICONS
Up and down airbag icons are engraved directly into the hard black switch face with high-precision equipment, giving you a durable OEM-style finish that lasts.
DUAL WHITE LED
The upper LED lights up when you press the switch up. The lower LED connects to your dash illumination circuit for consistent night-time backlighting.
STANDARD DIN FIT
The 37.5 mm x 21.2 mm mounting hole matches the standard DIN switch size used across ARB panels and most modern vehicle consoles. No cutting or modification needed.
Installation overview.
CHECK THE OPENING
Confirm your switch panel has a standard 37.5 mm x 21.2 mm DIN cutout. No modification needed if it does.
WIRE IT UP
Connect using the included wiring diagram. Tie the lower LED terminal to your dash illumination circuit if you want consistent backlighting.
PRESS TO FIT
Clip the switch into the panel opening until it seats flush. Test the up and down positions and check the LEDs before you close out the trim.