URNIETA Bull Bar
70 Series LandCruiser, 2007 to 2023
The factory plastic bumper on the 70 Series was never built for the work you put it through. The URNIETA bull bar replaces it with formed steel, shaped to the original headlight and grille line, for 2007 to 2023 (pre-facelift) models.
Item code: URNBULLBAR-70S-0723-FF
In high demand. We're working through a backlog of orders on this range, so this item may dispatch one to two weeks later than usual.
12-Month Australian Warranty.Backed by PVS Automotive, Sydney based support. Tax Deductible for Business. GST claimable if you are registered.Often fully deductible as a business expense. Check with your accountant.
Australian Owned and Operated.Australian Owned Certified · AO 08314
The front end the factory skipped.
The 70 Series has always been a working tool, but the factory plastic bumper has never matched the job. The URNIETA bull bar is a direct replacement, formed from steel in the URNIETA workshop and shaped to follow the original headlight and grille line. Your 70 Series still reads as a 70 Series, without the soft plastic front that was never going to last.
Mounting hardware picks up the factory chassis points with no permanent modification to your vehicle. You can specify optional fender flares at order to suit your build. It fits single cab, dual cab, troopy and wagon body styles in the 2007 to 2023 production window, and it's independently assessed for ADR compliance.
Built for the platform.
FORMED STEEL CONSTRUCTION
Single-piece steel build replaces the factory plastic bumper with a front end built for genuine work.
FACTORY-LINE FIT
The shape follows the original headlight and grille line, so your 70 Series profile stays intact front-on.
NO PERMANENT MODIFICATION
Mounting hardware uses your factory chassis points. No cutting or drilling to the vehicle structure.
Vehicle fitment.
Installation overview.
REMOVE FACTORY BUMPER
Unclip and unbolt the factory plastic front bumper and set it aside. Keep any hardware you plan to reuse.
PREPARE MOUNTING POINTS
Clean up the factory chassis mounting points and check fitment alignment before you go further.
OFFER UP THE BAR
With a second person, offer the bull bar into position and locate it on the factory chassis points.
FIT MOUNTING HARDWARE
Install the supplied mounting hardware and torque it to the spec in the included instructions.
FINAL CHECK
Confirm all fasteners are torqued, check clearances around the headlights and grille, and read the compliance statement before you drive.
Spec it
your way.
Not sure which setup suits your build? Get fitment advice, install guides, or talk to the PVS team before you buy. We are Sydney based and here to help.
