Right Side LED Push Switch Factory-style LED switch, direct fit for the LandCruiser and Hilux
This right side push switch drops straight into your Toyota LandCruiser or Hilux factory switch panel, no modification needed. White LED illumination and an OEM-finish bezel mean it looks like it was always there.
or 4 interest-free payments of $4.75 with Shop Pay & Afterpay
Item code: SW70-VW-RHS
Australisches Eigentum, australisch geführt.Australian Owned Certified · AO 08314Fills the gap properly.
Toyota's factory switch panels leave blanks where extra switches were always meant to go. Aftermarket options often look exactly like what they are, an afterthought. This switch is shaped, finished and lit to sit flush alongside your existing factory controls without standing out.
It's pre-wired and sized to the correct panel cutout for your LandCruiser or Hilux variant, so it drops in without modification. Pick your panel fitment from the options to get the right profile for your dash.
Built for the factory panel.
WHITE LED ILLUMINATION
An integrated white LED lights the switch face so you can find and operate it at night without it looking out of place next to your factory-lit controls.
DIRECT-FIT DESIGN
Shaped to the correct cutout dimensions for your panel variant, whether that's vertical, horizontal, square facelift or the 200 Series and Hilux N80 layout. No trimming, no adapters.
OEM-LOOK FINISH
The bezel and button finish are matched to Toyota's factory look, so your dash stays tidy instead of cluttered with mismatched hardware.
Vehicle fitment.
Installation overview.
SELECT YOUR VARIANT
Choose the fitment option that matches your vehicle's factory switch panel layout before you order. Get this right and the switch drops in without any trimming.
REMOVE THE BLANK OR OLD SWITCH
Pop out the existing blank or switch from the right side slot in your factory panel. Toyota panels typically release with a trim tool or flat blade.
CONNECT AND CLIP IN
Connect the pre-wired harness to your circuit, then press the switch firmly into the panel cutout until it clicks flush. The LED lights up when your ignition or accessory circuit is active.